Stamping

Punching

Based on customer requirements, we enlarged our production capacity of punching technology, another one processing possibility of electrical insulating materials, plastics, rubber, bandage, and slot insulation. This process leads to a significant increasing of manufacturing productivity, material utilization and thereby cost reduction during production in larger series.

We are individually able to recommend the most suitable tool for punching according to the product complexity, required material and series size. Production and testing of shape-complicated tool for punching takes about 2-3 months. Production of a simple tool/ modification of an existing punching tool, takes about several weeks. Standard lifetime of the tool is about 500 000 strokes, depending on the type of material.

Thickness of punched parts is normally to 3 - 5 mm.

Dimensional tolerances of length and diameter of holes may be according to the type of material and its strength and can be achieved from ± 0.1 mm. We will answer all your questions and for your individual requirements we prepare a complete quotation.

News
13.10. 2022

PLASTEX 2022

At the beginning of October 2022, we exhibited at the PLASTEX international fair, dedicated to plastics, rubber and composite comodities. Plastex was held as a part of the…
17.6. 2022

CWIEME 2022

At the beginning of May, we exhibited at the CWIEME trade fair in Germany. We met with our customers and suppliers. After a long covid break, these meetings were very nice. …
Contact
LABARA s.r.o.
Jindřichov 33
595 01 Velká Bíteš
tel.: +420 566 533 128
fax: +420 566 533 111
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Nahoru